1. |
Install the spring lower pad (D) so that the protrusions(A) fit
in the holes (C) in the spring lower seat (B).
|
2. |
Compress coil spring using special tool (09546-26000). Install
compressed coil spring into shock absorber.
|
3. |
After fully extending the piston rod, install the spring upper
seat and insulator assembly.
|
4. |
After seating the upper and lower ends of the coil spring (A)
in the upper and lower spring seat grooves (B) correctly, tighten new
self-locking nut temporarily.
|
5. |
Remove the special tool (09546-26000).
|
6. |
Tighten the self-locking nut to the specified torque.
|
Canister Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
IMS Control Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door")
...
Warning Messages
Shift to "P" position (for smart key system and automatic transaxle)
This warning message illuminates if you try to turn off the engine without
the shift lever in P (Park) position.
...