Kia Optima Manuals

Kia Sorento: Front Impact Sensor (FIS) Installation - SRSCM - Restraint - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Front Impact Sensor (FIS) Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Installation

  
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque
: 6.8 ~ 9.2 Nm (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb.ft)
3.
Connect the front impact sensor connector.
4.
Reconnect the battery negative cable.
5.
After installing the front impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Removal
   • Removal of the airbag must be performed according to the precautions/ procedures des ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

See also:

Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console (1). The sunroof can only be opened, closed, or tilted ...

Parking brake
Applying the parking brake Foot type To engage the parking brake, first apply the foot brake and then depress the parking brake pedal down as far as possible. Hand type To engage the parking ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P (Park) po ...

Categories


Copyright © www.ksmanual.com 2014-2024