1. |
Remove the front wheel and tire (A) from front hub .
|
2. |
Remove the brake caliper mounting bolts, and then place the brake
caliper assembly (B) with wire.
|
3. |
Remove the coking nut (A).
|
4. |
Remove the brake hose (A) and wheel speed sensor (B).
|
5. |
Remove the tie rod end ball joint (C) from the knuckle.
|
6. |
Disconnect the ball joint(A) from knuckle using the special tool
(09568-4A000).
|
7. |
Remove the lower arm (A) mounting bolt and nut from the knuckle.
|
8. |
Using a plastic hammer (A), disconnect driveshaft (C) from the
axle hub (B).
|
9. |
Remove the RH side cover (A).
|
10. |
Remove the mounting bolts (A,B) of Upper roll rod bracket (C).
|
11. |
Loosen the inner shaft mounting bolts and then disconnect the
inner shaft (A).
|
12. |
Insert a pry bar (A) between the transaxle case and joint case,
and separate the drive shaft (B) from the transaxle case.
|
13. |
Install in the reverse order of removal.
|
Components
1. Front seat belt
2. Second row seat belt
3. Third row seat belt
...
Seat Belt Pretensioner (BPT) Description
The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH
& RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner
seat belt helps to reduce ...
Specifications
Item
Specification
Power source
DC 14.4V (-) ground
Frequency range / Channel space
FM : 87.5 ~ 107.9 MHz / 200 KHz
AM : 530 ~ 1710 KHz / 10 KH ...