|
1. |
Using a screwdriver or remover, remove the quadrant inner cover
(A).
|
2. |
Push the lock pin (B), disconnect the tweeter speaker connector
(C).
|
3. |
Using a screwdriver (B), remove the door grip handle cover (A).
|
4. |
Using a screwdriver, remove the door inside handle cap (B).
|
5. |
After loosening the mounting screws, then remove the door trim
(A).
|
6. |
Push the hook (B), remove the inside handle cage (A)
|
7. |
Push the lock pin (A), disconnect the connectors (B).
|
8. |
Push the lock pin, disconnect the connectors (B).
|
9. |
Remove the door trim.
|
10. |
Install in the reverse order of removal.
|
1. |
Remove the door trim.
|
2. |
After loosening the mounting screws, then remove the inside handle
(A).
|
3. |
Install in the reverse order of removal.
|
1. |
Remove the front door trim.
|
2. |
Remove the glass mounting plug hole.
|
3. |
Carefully adjust the glass (B) until you can see the bolts, then
loosen them. Separate the glass from the glass run and carefully pull
the glass out through the window slot.
|
4. |
Install in the reverse order of removal.
|
1. |
Remove the door trim.
|
2. |
Drill out the rivets to remove the speaker (B) from the door module.
|
3. |
Disconnect the speaker connector (A).
|
4. |
Install in the reverse order of removal.
|
1. |
Remove the door trim.
|
2. |
Disconnect the connector (A), then loosen the mounting screws.
|
3. |
Remove the power window motor (B).
|
4. |
Install in the reverse order of removal.
|
1. |
Remove the following parts :
|
2. |
Loosen the outside handle base mounting screw (A).
|
3. |
Loosen the module mounting bolts.
|
4. |
After loosening the lach mounting screws, remove the module (A).
|
5. |
Push the lock pin (B), disconnect the connector (A).
|
6. |
Disconnect the clip (C).
|
7. |
Pull out the lock pin (A), disconnect the main connector (B).
|
8. |
Install in the reverse order of removal.
|
1. |
Remove the cap, loosen the mounting bolt.
|
2. |
Remove the outside handle cover (A).
|
3. |
Remove the outside handle (A)
|
4. |
Installation is the reverse the removal.
|
Inspection
Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front door module.
...
Driver Airbag (DAB) Module and Clock Spring Removal
1.
Set the front tires straight-ahead before removing the steering
wheel.
...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...