Kia Sorento: Front Disc Brake Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Brake System / Brake System / Front Disc Brake Inspection
Front brake disc thickness check
| 1. |
Check the brake pads for wear and fade.
|
| 2. |
Check the brake disc for damage and cracks.
|
| 3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
| 4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Front Brake Pad Check
| 1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
| 2. |
Check that grease is applied, to sliding contact points and the
pad and backing metal for damage.
|
Front brake disc runout check
| 1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
| 2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
| 3. |
If the runout does not exceed the limit specification, install
the brake disc after turning it 180В° and then check the runout of the
brake disc again.
|
| 4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
Front Disc Brake Replacement
Front brake pads
1.
Loosen the guide rod bolt (B) and then remove caliper body (A).
2.
Replace pad shim (D), pad retainers (C) and b ...
Front Disc Brake Installation
1.
Installation is the reverse of removal.
2.
Compress the piston into the caliper body using the SST (09581-11000).
...
See also:
Smart key precautions
The smart key will not work if any of the following occur: The smart key
is close to a radio transmitter such as a radio station or an airport which
can interfere with normal operation of the s ...
Rear Bumper Components
1. Rear bumper cover
2. Rear bumper lower bracket [RH]
3. Rear bumper lower bracket [LH]
4. Rear bumper side bracket [RH]
5. Rear bumper side bracket [LH]
...
Rear Stabilizer Bar Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
...
Copyright В© www.ksmanual.com 2014-2024