1. |
Remove the engine cover.
|
2. |
Disconnect the battery negative terminal.
|
3. |
Disconnect the front oxygen sensor connector (A) and the rear oxygen
sensor connector (B).
|
4. |
Remove the front muffler.
(Refer to Intake And Exhaust System - "Muffler")
|
5. |
Remove the heated oxygen sensor (A).
(Refer to Engine Control/Fuel System - "Heated Oxygen Sensor (HO2S)")
|
6. |
Remove the exhaust manifold heat protector (B).
|
7. |
Remove the exhaust manifold stay (A).
|
8. |
Remove the exhaust manifold (A) with the gasket (B).
When installing the intake manifold, tighten the nuts with pre-torque
first, and then tighten the nuts with specified torque in the sequence
shown.
|
9. |
Install in the reverse order of removal.
|
Circuit Diagram
...
Power Tailgate Latch Inspection
Power Tailgate Inspection With GDS
1.
Check the power Tailgate module input/output value by using the
GDS. If the operation of power Tailgate module is abnormal, replac ...