1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the evaporator temperature sensor connector.
|
3. |
Measure resistance between terminal “+” and “-” of the evaporator
temperature sensor.
Specification
|
4. |
Connect the evaporator temperature sensor connector.
|
5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of the harness connector.
|
Installation
1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
...
Fuel Line Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the F ...
IPM Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
...