ESC Hydraulic System Diagram |
1. |
ESC Non-operation : Normal braking.
|
2. |
ESC operation
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
In the event of inhibition of ABS functions by failure.
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is seperated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the Parking Brake Switch is ON or brake fluid level is low.
|
- |
When the EBD function is out of order .
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is seperated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the ESC function is inhibited by system failure.
|
- |
When the ESC control is operating. (Blinking - 2Hz)
|
- |
During diagnostic mode.(Except standard mode)
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization mode after IGN ON. (continuously 3 seconds).
|
- |
ESC Off lamp is On when driver input the ESC Off switch.
|
Room Lamp Inspection
1.
Remove the room lamp assembly then check for continuity between
terminals.
[Sunroof]
[General]
...
Active ECO operation
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle
system operating parameters. Fuel efficiency depends on the driver's driving habit
and road condition.
...
Changing tires
1.Park on a level surface and apply the parking brake firmly.
2.Place the transaxle shift lever in R (Reverse) with manual transaxle or P (Park)
with automatic transaxle.
3.Activate the hazard wa ...