Roll road Bracket
1. |
Remove the roll road bracket(A).
|
2. |
Install in the reverse order of removal.
|
Engine Mounting Bracket
1. |
Install the jack to the edge of upper oil pan to support the engine.
|
2. |
Disconnect the ground cable (A), and then remove the engine mounting
support bracket (B).
|
3. |
Remove the reservoir tank.
(Refer to Cooling System - "Reservoir Tank")
|
4. |
Remove the engine mounting bracket(A).
|
5. |
Install in the reverse order of removal.
|
Transaxle Mounting Bracket
1. |
Remove the air duct.
(Refer to Intake and Exhaust System - "Air Cleaner")
|
2. |
Remove the battery and tray.
(Refer to Engine Electrical System - "Battery")
|
3. |
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
|
4. |
Install the jack to the edge of transaxle.
|
5. |
Disconnect the ground cable(A).
|
6. |
Remove the service cover(A).
|
7. |
Remove the transaxle mounting bolts(A).
|
8. |
Remove the transaxle mounting bracket(A).
|
9. |
Install in the reverse order of removal.
|
Canister Installation
1.
Install in the reverse order of removal.
...
Relay Box (Passenger Compartment) Installation
1.
Install IPM(Intelligent intergrated Platform Module).
2.
Connect the IPM connector.
3.
Install the crash pad ...
Component Location
1. Driver power window main switch
2. Passenger window switch
3. Front window motor
4. Rear window motor
5. Rear window switch
...