1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the ECM Connector (A).
|
3. |
Remove the battery.
(Refer to Engine Electrical System - "Battery")
|
4. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
5. |
Remove the mounting bolt (A) and nuts (B), and then remove the
ECM (C).
|
6. |
After romoving the installation nuts (A) and screws (B), romove
the ECM (C) from the bracket.
|
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
IMS Control Switch Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Using Bluetooth® Wireless Technology
Phone Menu Screen
Phone Menus
With a Bluetooth® Wireless Technology device connected, press the
key to display
the Phone menu screen.
1) Favorite :
Up to 20 frequently used contacts saved f ...