• |
After replacing the ECM of the vehicle with the immobilizer, the
following procedure must be performed.
|
1) |
[If installing a used ECM]
|
1. |
Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body
Electrical System - "Immobilizer System - Repair procedures")
|
2. |
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure
using GDS. (Refer to "Body Electrical System - "Immobilizer System -
Repair procedures")
|
2) |
[If installing a new ECM]
Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical
System - "Immobilizer System - Repair procedures")
|
• |
After replacing the ECM of the vehicle with the smart key system
(button start), the following procedure must be performed.
|
1) |
[If installing a used ECM]
|
1. |
Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body
Electrical System - "Smart key System - Repair procedures")
|
2. |
After finishing "ECM Neutral Mode", turn IGN ON then OFF using
the smart key or start button. Then the ECM learns information on the
smart key automatically.
|
2) |
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then
the ECM learns information on the smart key automatically.
|
• |
After replacing ETC module or ECM, the ETC adaptive value must
be reset / relearned.
(Refer to "Engine Control System - ETC - adjustment")
|
Seat warmer (if equipped)
The seat warmer is provided to warm the front seats during cold weather.
With the ignition switch in the ON position, push either of the switches to warm
the driver's seat or the front passeng ...
Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals
of multi-function switch connector.
...
Oil Cooler Removal
1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap
to help drain the coolant faster.
2.
Disconnect the oil cooler coo ...