• |
Adjust a shift cable.
|
• |
Refill engine with engine oil.
|
• |
Refill a transaxle with fluid.
|
• |
Refill power steering fluid.
|
• |
Refill a radiator and a reservoir tank with engine coolant.
|
• |
Place a heater control knob on "HOT" position.
|
• |
Clean battery posts and cable terminals and assemble.
|
• |
Inspect for fuel leakage.
|
- |
After assemble the fuel line, turn on the ignition switch (do not operate
the starter) so that the fuel pump runs for approximately two seconds
and fuel line pressurizes.
|
- |
Repeat this operation two or three times, then check for fuel leakage
at any point in the fuel line.
|
• |
Bleed air from the cooling system.
|
- |
Start engine and let it run until it warms up. (until the radiator fan
operates 3 or 4 times.)
|
- |
Turn Off the engine. Check the level in the radiator, add coolant if
needed. This will allow trapped air to be removed from the cooling system.
|
Parking brake
Applying the parking brake
Foot type
To engage the parking brake, first apply the foot brake and then depress the
parking brake pedal down as far as possible.
Hand type
To engage the parking ...
Rear Lower Arm Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of below items;
-
Fill vent valve
-
F ...