Kia Sorento: Dynamic Damper Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Removal
| 1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
| 2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
|
| 3. |
Remove the remove the both side of band (B) of the dynamic damper
(A).
|
| 4. |
Fix the driveshaft (A) with a vice (B) as illustrated.
|
| 5. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper when the dynamic damper is removed.
|
| 6. |
Seperate the dynamic damper (A) from the shaft (B) carefully.
|
Dynamic Damper Components
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
...
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
See also:
Valve Body Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
Smart key unit Components
Connector Pin Information
No.
Connector A
Connector B
Connector C
1
V_BAT load
C_CAN Low
SSB illumination ground
2
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Copyright © www.ksmanual.com 2014-2024