1. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
|
2. |
Install the dynamic damper.
|
3. |
Install the dynamic damper band (A).
|
4. |
Using the SST(09495-3K000), secure the TJ boot bands (B).
|
5. |
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ joint”)
|
6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
Compressor Inspection
1.
Check the plated parts of the disc & hub assembly (A) for color
changes, peeling or other damage. If there is damage, replace the clutch
set.
...