Kia Sorento: Drive Belt Removal and Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Timing System / Drive Belt Removal and Installation
| 1. |
For release the tension, turn the drive belt tensioner counterclockwise
then remove the drive belt (A).
|
| 2. |
Install the drive belt (A).
Rotate the drive belt tensioner arm (A) counterclockwise moving the
tensioner pulley bolt with wrench. After putting the belt on the tensioner
pulley, release the tensioner pulley slowly.
Crankshaft pulley → A/C pulley → Alternator pulley → Idler #1 pulley
→ Idler #2 pulley → Water pump pulley → Tensioner pulley.
|
Components
1. Intake camshaft
2. Exhaust camshaft
3. Intake CVVT assembly
4. Exhaust CVVT assembly
5. Timing chain
6. Timing chain guide
7. Timing chain tensioner arm
8. Timin ...
Drive Belt Inspection
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
...
See also:
Starter Disassembly
1.
Disconnect the M-terminal (A) on the magnet switch assembly (B).
2.
After loosening the screws (A), detach the magnet switch assembly ...
Blind Spot Detection Switch Inspection
1.
Disconnect the BSD switch connector.
2.
Operate the BSD switch, then check for continuity between terminals
of BSD switch connec ...
Active ECO operation
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle
system operating parameters. Fuel efficiency depends on the driver's driving habit
and road condition.
...
Copyright В© www.ksmanual.com 2014-2024