Coupling Maintenance Precautions
Maintain the coupling at a horizontal level.
|
1. |
Remove the 4WD coupling assembly bolts (A-3ea) mounted to the
rear propeller shaft (B).
|
2. |
Using a flat tool, separate the propellar shaft from 4WD coupling
assembly.
|
3. |
Disconnect the pressure sensor connector (A) and Oil hydraulic
Motor connector (B).
|
4. |
Loosen the coupling assembly mounting bolts (A-4ea).
|
5. |
Using a flat tool, separate the 4WD coupling assembly from the
rear differential carrier assembly.
|
1. TCM connector and terminal function
...
Balance Shaft & Oil Pump Removal
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A) ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST/ :
For a single wiping cycle, move the lever to this (MIST/ ) position andrelease
it. The wipers will operate continuously if the l ...