In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. So don’t do any repair work right
after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
3. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
|
4. |
Remove the injector form (A).
|
5. |
Disconnect the injector connectors (A) and the rail pressure sensor
connector (B).
|
6. |
Remove the high pressure fuel pipe (C).
|
7. |
Remove the installation bolt (D), and then remove the delivery
pipe and injector assembly from the engine.
|
Components
1. HECU module
2. Front wheel speed sensor
3. Rear wheel speed sensor
4. Yaw rate & Lateral G sensor
5. ABS Warning lamp
6. Parking brake/EBD warning lamp
7. ESC F ...
Piston and Connecting Rod Components
1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
5. Connecting rod upper bearing
6. Connecting rod lower bearing
7. Connecting rod bearing cap
...
Front Wiper Motor Component Location
1. Cap
2. Nut
3. Wiper arm & blade
4. Retainer
5. Cowl top cover
6. Bolt
7. Wiper motor & linkage assembly
8. Wiper motor connector
...