1. |
Install the intakeCVVT assembly(A), exhaust CVVT assembly(B) and camshaft(C).
|
2. |
Install the camshafts.
|
3. |
Install camshaft bearing caps (A) in their proper locations.
Tightening order
Group A → Group B → Group C.
|
4. |
Install the high pressure fuel pump(A).
|
5. |
Install the ratchet of the timing chain tensioner by pushing the link
up using a thin rod.
|
6. |
Install the service hole bolt of the timing chain cover.
|
7. |
Install the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
|
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...