Never attempt to measure the circuit resistance of the airbag
module even if you are using the specified tester. If the circuit resistance
is measured with a tester, accidental airbag deployment will result
in serious personal injury.
|
Drive Belt Removal and Installation
1.
For release the tension, turn the drive belt tensioner counterclockwise
then remove the drive belt (A).
2.
Install the drive be ...
Relay Box (Passenger Compartment) Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
...
Engine Control Module (ECM) Adjustment
•
After replacing the ECM of the vehicle with the immobilizer, the
following procedure must be performed.
1)
[If installing a used ECM]
...