1. |
Install the main bearings.
|
2. |
Install the thrust bearings.
Install the 2 thrust bearings(A) under the No.3 journal position of
the cylinder block with the oil grooves facing outward.
|
3. |
Install the oil jet (A).
|
4. |
Place the crankshaft(A) on the cylinder block.
|
5. |
Place the main bearing caps on cylinder block.
|
6. |
Install the main bearing cap bolts.
|
7. |
Check crankshaft end play.
|
8. |
Install piston and connecting rod assemblies.
(Refer to Cylinder Block - "Piston And Connecting Rod")
|
Tilt and telescopic steering
Tilt and telescopic steering allows you to adjust the steering wheel before you
drive.You can also raise it to give your legs more room when you exit and enter
the vehicle.
The steering wheel shoul ...
Front Wiper Motor Installation
1.
Install the wiper motor.
2.
Install the crank arm.
Torque :
12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf. ...
Front Wheel Speed Sensor Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...