1. |
Check the crankshaft bearing oil clearance.
Crankshaft Bore Identification Mark
Letters have been stamped on the block as a mark for the size of each
of the 5 main journal bores.
Use them, and the numbers or bar stamped on the crank (marks for main
journal size), to choose the correct bearings.
Cylinder Block Specifications
Crankshaft Journal Identification Mark
Crankshaft Specifications
Crankshaft Bearing Identification Mark
Crankshaft Bearing Specifications
Selection Chart For Crankshaft Bearings
|
2. |
Check crankshaft end play.
Using a dial indicator, measure the thrust clearance while prying the
crankshaft back and forth with a screwdriver.
If the end play is greater than maximum, replace the thrust bearings
as a set.
|
3. |
Inspect main journals and crank pins.
Using a micrometer, measure the diameter of each main journal and crank
pin.
|
SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body.
...
Room Lamp Inspection
1.
Remove the room lamp assembly then check for continuity between
terminals.
[Sunroof]
[General]
...
Shift Cable Components
1. Shift lever mounting bolt
2. Shift lever assembly
3. Shift cable assembly
4. Shift lever knob & boots assembly
5. Manual control lever
6. Retainer
...