Kia Sorento: Console Replacement - Exterior - Body (Interior and Exterior) - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Console Replacement

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body (Interior and Exterior) / Exterior / Console Replacement

Floor Console Assembly Replacement
  
•
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the floor console upper tray (A).

2.
Disconnect the connectors (A).

3.
Remove the gear boots (B) and gear knob (A).

4.
Using a screwdriver or remover, remove the console upper cover (A).

5.
Disconnect the connectors (A).

6.
Using a screwdriver or remover, remove the console side cover (A).
[LH]

[RH]

7.
Remove the console armrest tray (A).

8.
Remove the console tray met (A).

9.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).

10.
Disconnect the connector (A).

11.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
Rear Console Cover Replacement
  
•
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the rear console cover (A).

2.
Disconnect the power outlet connector (A).

3.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
Console Armrest Replacement
  
•
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
After loosening the mounting screws, then remove the console armrest cover (A).

2.
After loosening the mounting screws, then remove the console armrest (A).

3.
Install in the reverse order of removal.
  
•
Replace any damaged clips.
Console Components
[M/T] 1. Floor console assembly 2. Console upper cover 3. Console side cover [LH] 4. Console side cover [RH] 5. Rear console cover 6. Floor console mounting ...

Crash Pad Components
1. Main crash pad assembly 2. Crash pad side cover [LH] 3. Crash pad side cover [RH] 4. Center fascia panel 5. Crash pad lower panel 6. Reinforce panel ...

See also:

Master Cylinder Components
1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bolts ...

Component Location
1. Overdrive Clutch (OD/C) 2. One way Clutch (OWC) 3. Low & Reverse Brake (LR/B) 4. Underdrive Brake (UD/B) 5. 26 Brake(26/B) 6. 35R Clutch (35R/C) 7. Damper Clu ...

Copyright © www.ksmanual.com 2014-2024