Kia Sorento: Compressor Oil Specification
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor Oil Specification
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
|
| 2. |
Compressor (PAG) oil varies according to compressor model. Be
sure to use oil specified for the model of compressor.
|
Handling of Oil
| 1. |
The oil should be free from moisture, dust, metal powder, etc.
|
| 2. |
Do not mix with other oil.
|
| 3. |
The water content in the oil increases when exposed to air. After
use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs
moisture very easily.)
|
| 4. |
The compressor oil must be stored in steel containers, not in
plastic containers.
|
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas
leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system
Front only : PAG 120 ± 10cc (4.1±0.3oz.)
Front & Rear : PAG 180 ± 10cc (6.1±0.3oz.)
|
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant
in the system. When checking the amount of oil in the system, or replacing any
component of the system, the compressor must run in advance for oil return operation.
The procedure is as follows:
| 1. |
Open all the doors and engine hood.
|
| 2. |
Start the engine and air conditioning switch to "ON" and set the
blower motor control knob at its highest position.
|
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000
rpm in order to operate the system.
|
| 4. |
Stop the engine.
|
Component Location
[Engine Room]
1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
Refrigerant Line Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
...
See also:
Seat Heater Component Location
...
Rear Disc Brake Inspection
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Dynamic Damper Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
Copyright © www.ksmanual.com 2014-2024