1. |
Remove the engine room under cover by loosening the mounting clip
(A) and bolts (B).
|
2. |
Separate the front portion of the front wheel guard from the wheel
base.
(Refer to Body - "Body Side Moldings")
|
3. |
Remove the engine room right side cover.
|
4. |
Loosen the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
|
5. |
Remove the center bolt (A) while holding the pulley with a disc
& hub bolt remover (09977-25100).
|
6. |
Loossen the hub bolts and then remove the hub assembly.
|
7. |
Remove the pulley (B) after removing the snap ring (A) with a
snap ring plier.
|
8. |
Reassemble in the reverse order of disassembly.
|
Cruise Control
The cruise control system is engaged by the cruise "ON/OFF" main switch
located on right of steering wheel column. The system has the capability to
cruise, coast, accelerate and res ...
Spark Plug Removal
1.
Remove the ignition coil.
(Refer to Ignition System - "Ignition Coil")
2.
Using a spark plug wrench, remove the spark plu ...
Front Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...