Kia Sorento: Component Location
| [Engine Room] |
| 1. Receiver-drier 2. Condenser 3. Ambient temperature Sensor 4. Compressor 5. Discharge Hose |
6. Suction & Liquid Tube Assembly 7. Service Port (Low Pressure) 8. Service Port (High Pressure) 9. A/C Pressure Transducer 10. Expansion Valve |
| [Interior] |
| 1. In-car sensor 2. Heater & A/C Control Unit (Manual) 3. Heater & A/C Control Unit (DATC) |
4. Photo Sensor 5. Heater & Blower Unit |
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
See also:
Description
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is below a ...
Battery Sensor Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the bat ...
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the Front End Module (FEM).
They are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of ...
Copyright В© www.ksmanual.com 2014-2024