1. |
Measure the resistance between the terminals.
|
2. |
The measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Rear Stabilizer Bar Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Transaxle Oil Temperature Sensor Description
Transaxle Oil Temperature Sensor(OTS) monitors the automatic transaxle
fluid's temperature and conveys the readings to TCM. It is an Negativen Thermal
Coefficient(NTC) sensor whose resist ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...