Kia Sorento: Battery Sensor Installation
1. |
Install in the reverse order of removal.
Battery sensor cable installation
bolt:
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)
Battery (-) terminal l tightening
nut:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
• |
For the vehicle equipped with a battery sensor,
be careful not to damage the battery sensor when the
battery is replaced or recharged.
|
1. |
When replacing the battery, it should be same
one (type, capacity and brand) that is originally installed
on your vehicle. If a battery of a different type is
replaced, the battery sensor may recognize the battery
to be abnormal.
|
2. |
When installing the ground cable on the negative
post of battery, tighten the clamp with specified torque.
An excessive tightening torque can damage the PCB internal
circuit and the battery terminal .
|
3. |
When recharging the battery, ground the negative
terminal of the booster battery to the vehicle body.
|
|
|
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the bat ...
See also:
Oil hydraulic Motor(Actuator) Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator
Coupling")
2.
Keep goin ...
Smart key unit Inspection
Smart Key Unit
-
Refer to BE group - inspection / self diagnosis with scan tool.
Smart Key Switch
-
Refer to BE group - inspection / self diag ...
Immobilizer Control Unit Installation
1.
Install the immobilizer control unit after connecting the unit
connector.
2.
Install the crash pad lower panel.
...