1. |
Make sure the ignition switch and all accessories are in the OFF
position.
|
2. |
Disconnect the battery cables (negative first).
|
3. |
Remove the battery from the vehicle.
|
4. |
Inspect the battery tray for damage caused by the loss of electrolyte.
If acid damage is present, it will be necessary to clean the area with
a solution of clean warm water and baking soda. Scrub the area with
a stiff brush and wipe off with a cloth moistened with baking soda and
water.
|
5. |
Clean the top of the battery with the same solution as described
above.
|
6. |
Inspect the battery case and cover for cracks. If cracks are present,
the battery must be replaced.
|
7. |
Clean the battery posts with a suitable battery post tool.
|
8. |
Clean the inside surface of the terminal clamps with a suitable
battery cleaning tool. Replace damaged or frayed cables and broken terminal
clamps.
|
9. |
Install the battery in the vehicle.
|
10. |
Connect the cable terminals to the battery post, making sure tops
of the terminals are flush with the tops of the posts .
|
11. |
Tighten the terminal nuts securely.
|
12. |
Coat all connections with light mineral grease after tightening.
|
Instrument Cluster Inspection
1.
Check the suspected area as below table when the warning light
is error.
NO
Warning light
Description
Communicatio ...
Description
The ECM (Electro Chromatic inside rear view Mirror) is for dimming the
reflecting light from a vehicle behind at night, in order the user not to be
dazzled by the light. The forward facing se ...
For best battery service
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spill ...