1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
|
3. |
Using a screwdriver or remover, remove the crash pad side cover
(A).
|
4. |
Disconnect the stopper (B) from the glove box (A).
|
5. |
Disconnect the air damper (A) from the glove box (B).
|
6. |
Disconnect the pins (A) and then remove the glove box (B).
|
7. |
After loosening the mounting screws, then remove the crash pad
side garnish [RH] (A).
|
8. |
After loosening the mounting screws, then remove the crash pad
under cover (A).
|
9. |
After loosening the mounting screws, then remove the glove box
housing (A).
|
10. |
Disconnect the glove box lamp connector (A).
|
11. |
Disconnect the connector and then remove the auto defogging actuator
(A) after loosening the mounting screws.
|
12. |
Install in the reverse order of removal.
|
26 Brake Control Solenoid Valve(26/B_VFS)
26Brake control solenoid valve(26/B) is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the 26Brake.
...
Oil Pump Description
The oil pump is built-in as a single unit with the 26Brake chamber. Rotation
of the pump builds the hydraulic pressure needed for the lubrication of the
various parts of the transaxle and ope ...
Rear Disc Brake Replacement
1.
Remove the rear wheel & tire.
2.
Loosen the guide rod bolt (B) and pivot the caliper (A) up out
of the way.
...