Kia Sorento: Auto Defogging Actuator Description - Heater - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Auto Defogging Actuator Description

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Auto Defogging Actuator Description

The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mode actuator.
Mode Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side crash pad side cover. ...

Auto Defogging Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defoggin ...

See also:

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedu ...

Blind Spot Detection Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") ...

Interior D
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front pillar ...

Copyright В© www.ksmanual.com 2014-2024