1. |
Disconnect the negative (-) battery terminal.
|
2. |
After loosening the mounting screws, then remove the tailgate
side trim (A).
(Refer to Body - "Tailgate")
|
3. |
Remove the anti-pinch strip sensor connector.
|
4. |
Remove the anti-pinch strip (A) after removing the clips (5EA).
|
Piston and Connecting Rod Inspection
Connecting Rod
1.
Check the connecting rod end play.
Using a feeler gauge, measure the end play while moving the connecting
rod back and forth.
...
Fuel Pressure Test (Low pressure system)
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...
Hazard Lamp Switch Installation
1.
Install the heater control unit to the center fascia panel.
2.
Install the center fascia panel.
...