Kia Sorento: Ambient Temperature Sensor Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Ambient Temperature Sensor Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Remove the front bumper.
(Refer to Body - "Front Bumper")
|
| 3. |
Disconnect ambient temperature sensor.
|
| 4. |
Check the resistance of the ambient temperature sensor between
terminals 1 and 2 whether it changes by changing the ambient temperature.
Specification
|
| 5. |
If the measured resistance is not within specification, substitute
with a known-good ambient temperature sensor and check for proper operation.
|
| 6. |
Replace the ambient temperature sensor if it is proved that there
is a problem with the sensor.
|
Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser
and detects ambient air temperature. It is a negative type thermistor; resistance
will increase with lower temperature, ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper")
...
See also:
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
...
Setup
Display Settings
Press the
key Select
[Display] through
TUNE knob or
key Select
menu through
TUNE knob
Mode Pop up
[Mode Pop up]
Changes selection mode
During On state, pr ...
Copyright © www.ksmanual.com 2014-2024