1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Remove the floor console.
(Refer to Body - "Floor console")
|
4. |
Loosen the bolts and then remove the rear air vent duct (A).
|
5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
6. |
Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove
the SRSCM.
|
You must remove or install SRSCM or other SRS components with
the ignition swich OFF to avoid accidental airbag deployment.
|
Windshield Deicer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...
Component Location
1. Slide motor
2. Front height motor
3. Rear height motor
4. Lumber support motor
5. Power seat switch
6. Reclining motor
7. Reclining switch
8. Lumber support swit ...
Temperature Control Actuator Replacement
[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's si ...