1. |
Turn the ignition switch OFF.
|
2. |
Remove the surge tank. [G3.3 GDI]
(Refer to Engine Mechanical System - "Surge Tank")
|
3. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
4. |
Pull up the lock of the HECU connector (A) and then disconnect
the connector.
|
5. |
Disconnect the brake tubes from the HECU by unlocking the nuts
counterclockwise with a spanner.
|
6. |
Loosen the HECU bracket nuts (A) and then remove HECU and bracket.
|
7. |
Remove the bolts and then remove the bracket from HECU.
|
Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...
Front Wheel Transfer Assembly Removal
It is not recommended to overhaul the transfer assembly because
a special three-dimensional measuring instrument is requ ...
Transaxle Control Module (TCM) Removal
When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the ...