ESC Hydraulic System Diagram |
1. |
ESC Non-operation : Normal braking.
|
2. |
ESC operation
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
In the event of inhibition of ABS functions by failure.
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is seperated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the Parking Brake Switch is ON or brake fluid level is low.
|
- |
When the EBD function is out of order .
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is seperated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the ESC function is inhibited by system failure.
|
- |
When the ESC control is operating. (Blinking - 2Hz)
|
- |
During diagnostic mode.(Except standard mode)
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization mode after IGN ON. (continuously 3 seconds).
|
- |
ESC Off lamp is On when driver input the ESC Off switch.
|
Head Lamps Inspection
1.
Check-points upon head lamp failure (HID)
(1)
Check the battery voltage. (Low beam will be on when the
battery voltage above 9V.) ...
Starter Relay Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).
...
Front seat adjustment - manual
Forward and backward
To move the seat forward or backward:
1. Pull the seat slide adjustment lever up and hold it.
2. Slide the seat to the position you desire.
3. Release the lever and make sur ...