Parking brake pedal Type |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
4. |
Remove the parking brake cable adjusting nut (A) and the fixing
clip (B), and then remove the parking brake pedal.
|
5. |
Remove the floor console.
(Refer to Body - "Floor console")
|
6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
7. |
Raise the vehicle, and make sure it is securely supported.
|
8. |
Remove the rear wheel & tire.
|
9. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
10. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
11. |
Installation is reverse of removal.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the floor console.
(Refer to Body - "Floor console")
|
3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
4. |
Raise the vehicle, and make sure it is securely supported.
|
5. |
Remove the rear wheel & tire.
|
6. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
7. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
8. |
Installation is reverse of removal.
|
Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor ...
Starter Removal
1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - &quo ...
Parking Assist Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
...