1. |
Remove the floor console.
(Refer to Body - "Floor console")
|
2. |
Apply the brake pedal 20 times with the force of 10kgf after bleeding.
Then, for the cable to settle in, apply the parking brake full stroke
more than 3 times.
|
3. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
4. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
5. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
6. |
Install the floor console.
(Refer to Body - "Floor console")
|
IMS Power Seat Control Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Circuit Diagram
...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD (Emergency Fastening Device)).
The pre-tensioner seat belts may be act ...