1. |
Install the parking brake lever assembly (A).
|
2. |
Install the parking brake cable (B) and tighten the adjusting
nut (A).
|
3. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
4. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
6. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
7. |
Reconnect the connector (A) of parking brake switch.
|
8. |
Install the floor console.
(Refer to Body - "Floor console")
|
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Illuminated ignition switch (if equipped)
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the igniti ...
SS-A Solenoid Valve(ON/OFF)
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-A Solenoid valve(ON/OFF) is installed at valve body.
...