1. |
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
|
2. |
Install the operating lever assembly (D) and the upper return
spring (C).
|
3. |
Install the adjuster assembly (B) and the lower return spring
(A).
|
4. |
Install the hub assembly.
(Refer to Drive shaft and axle - "Rear hub - carrier")
|
5. |
Install the parking brake cable (B), and then install the fixing
clip (A).
|
6. |
Install the rear brake disc, then adjust the rear brake shoe clearance.
|
7. |
Install the brake caliper assembly.
(Refer to Brake system - "Rear disc brake")
|
8. |
Install the tire and wheel, after installing the plug on the disc.
|
9. |
If the parking brake shoe or the brake disc are replaced a newly
one, perform the brake shoe bed-in procedure.
|
Pressure Sensor Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an
oil pressure. And then it presses a multiple disk clutch and transfers the generated
torque into rear wheels. Its torque ...
Good driving practices
Never move the gear shift lever from P (Park) to any other position with
the accelerator pedal depressed.
Never move the gear shift lever into P (Park) when the vehicle is in motion.
Be sure ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...