1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check that grease is applied, to sliding contact points and the
pad and backing metal for damage.
|
1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
3. |
If the runout exceeds the limit specification, install the brake
disc after turning it 180° and then check the runout of the brake disc
again.
|
4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.62 ± 10% [20°C (68°F)]
Secondary Coil Re ...
Ignition Coil Circuit Diagram
...
Lubricants
Items
Lubricants
Quantity (g)
Front driveshaft
LSJ 104
SH06-VX21
240 ~ 255
UBJ 104
RBA
165 ~ 175
LSJ 100
...