1. |
Installation is the reverse of removal.
|
2. |
Compress the piston into the caliper body using the SST (09581-11000).
|
3. |
After installation, bleed the brake system.
(Refer to Brake system - "Brake system Bleeding")
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
Components Location
1. Automatic transaxle
2. Shift cable bracket
3. Inhibitor switch connector
4. Manual control lever
5. Automatic transaxle mounting support bracket
6. Solenoid valve conne ...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 (or 3) fuse panels, one located in the driver’s side panel
bolster, the other in the en ...