1. |
Loosen the guide rod bolt (B) and then remove caliper body (A).
|
2. |
Replace pad shim (D), pad retainers (C) and brake pads (B) in
the caliper carrier (A).
|
3. |
Compress the piston into the caliper body using the SST (09581-11000).
|
4. |
Place the caliper body (A) on the caliper carrier and tighten
the guide rod bolt (B).
|
5. |
Install the rear wheel & tire.
|
Electric power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the
engine is off or if the power steering system becomes inoperative, the vehicle may
still be steered, but it will require ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the inject ...
Alternator Specification
Alternator
Item
Specification
Rated voltage
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator bui ...