1. |
Pre-tighten the bracket fixing bolt (A) in dash panel.
|
2. |
Install the brake booster and brake pedal member fixing nuts (A)
securely.
|
3. |
Tighten the bolt (A) securely in dash panel.
|
4. |
Install the snap pin (A) and clevis pin (B).
|
5. |
Install the stop lamp switch securely.
|
6. |
Connect the stop lamp switch connector (A).
|
7. |
Adjust the brake pedal height and free play.
|
8. |
Check the brake pedal operation after installing the brake pedal.
|
9. |
Install the shower duct (A).
|
10. |
Install the crash pad lower panel.
|
11. |
Reconnect the battery negative cable.
|
Installation
1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
...
Parking Brake Assembly Removal
Parking Brake Shoe
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear tire and wheel.
3.
...
Component Location
1. IPM (Intelligent intergrated Platfrom Moduel)
2. Ultrasonic sensor
...