1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel and reinforce panel.
(Refer to Body - "Crash pad lower panel")
|
3. |
Remove the shower duct (A).
|
4. |
Disconnect the stop lamp switch connector (A).
|
5. |
Remove the brake pedal member mounting nut (A).
|
6. |
Remove the snap pin (A) and clevis pin (B).
|
7. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Injector
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling as it exits th ...
Valve Body Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...