Kia Sorento: Emergency Fastening Device (EFD) Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the EFD cover pad (A).
|
| 3. |
Remove the seat belt after pushing the lock pin with a fiat-tip
screwdriver (B).
|
| 4. |
Remove the door scuff trim. (Refer to the Body group- Interior
trim)
|
| 5. |
Remove the center pillar trim. (Refer to the Body group- Interior
trim)
|
| 6. |
Disconnect the EFD connector (A).
|
| 7. |
Loosen the EFD mounting bolt (B) and remove the EFD.
|
Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on driver and pass ...
Emergency Fastening Device (EFD) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
See also:
Tilting the sunroof
Before opening or closing the sunroof, open the roller blind (refer to the following
page for instructions on how to use the roller blind).
To open the sunroof, push the sunroof control lever upwa ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding”
procedure.
1.
...
Front Washer Motor Installation
1.
Reassemble the washer reservoir.
Before installing the pump motor, che ...
Copyright © www.ksmanual.com 2014-2024