Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
3. |
Install the seatbelt buckle & buckle switch.
|
4. |
Install the front seat assembly. . (Refer to the Body group- Front
seat)
|
5. |
Reconnect the battery negative cable.
|
6. |
After installing the seat belt buckle switch, confirm proper system
operation:
|
Removal
1.
Remove the tailgate trim in the trunk after removing the screws
and clips.
(Refer to Body - "Tailgate")
2.
Remove the ...
Rear Stabilizer Bar Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...