Kia Sorento: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Front Impact Sensor (FIS) Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Removal

  
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Disconnect the front impact sensor connector (A).
3.
Remove the front impact sensor mounting bolt (B).

Front Impact Sensor (FIS) Components
...

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Rear combination lamp Removal
1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconn ...

Copyright © www.ksmanual.com 2014-2024