When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line (95800-1U00) in
order to have the correct inflation warning thresholds set.
|
1. |
Disconnect vehicle battery (-)cable.
|
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
3. |
Remove faulty part and fit bracket assembly to new part.
|
4. |
Secure new part to vehicle and fit connector.
|
5. |
Re-connect battery and turn Ignition on.
Vechicle Name Writing
VIN Writing
|
SRS Care
The SRS is virtually maintenancefree and so there are no parts you can safely
service by yourself. If the SRS air bag warning light does not illuminate, or continuously
remains on, have your vehicle ...
Rear combination lamp Removal
1.
Disconnect the negative (-) battery terminal.
[Outside]
2.
Loose the screws (2EA) holding the rear combination lamp then
disconn ...
Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge control solen ...