Kia Sorento: TPMS Sensor Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Removal

Tire Removal

1.

Deflate tire & remove balance weights.

•	The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.

•	Avoid tire/tool contact with the valve on dismount.

•	Dismount should end near the valve.

Sensor Removal

Handle the sensor with care.

1.

Remove the valve nut.

The valve nut should not be re-used.

2.	Discard the valve assembly.

TPMS Sensor Description

1. Mode (1) Configuration State A. All sensors should be in the Low Line state. ...

TPMS Sensor Installation

Sensor Fit • Handle the sensor with care. • ...

See also:

Hood Adjustment
Adjust Hood 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjust th ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A). ...

Seat Heater Switch Inspection
Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel (A). (Refer to Body - &q ...

Categories

Copyright © www.ksmanual.com 2014-2024