1. |
Remove the rear wheel & tire.
|
2. |
Remove the parking brake cable.
(Refer to "Parking Brake System" in BR group)
|
3. |
Loosen the bolt and then remove the trailing arm (A).
|
4. |
Remove the shock absorber upper mounting.
[2WD]
[4WD]
|
5. |
Remove the rear muffler.
|
6. |
Loosen the bolt and then remove the propellar shaft (A).
|
7. |
Loosen the mounting bolts and then remove the rear cross member
(A) with the frame.
|
8. |
Remove the rear lower arm.
(Refer to the lower arm)
|
9. |
Remove the rear shock absorber.
(Refer to the rear shock absorber)
|
10. |
Remove the rear upper arm.
(Refer to the rear upper arm)
|
11. |
Remove the trailing arm.
(Refer to the trailing arm)
|
12. |
Remove the rear assist arm.
(Refer to the rear assist arm)
|
13. |
Remove the drive shaft.
(Refer to "Rear Drive Shaft" in DS group)
|
14. |
Remove the differential carrier.
(Refer to "Differential Carrier" in DS group)
|
15. |
Installation is the reverse of removal.
|
EBD (Electronic Brake-force Distribution)
The EBD system (Electronic Brake force Distribution) as a sub-system of
the ABS system is to control the maximum braking effectiveness by the rear wheels.
It further utilizes the efficiency ...
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.5 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2]
A/F Ratio (λ)
...
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...